| PRO-SW3000XL
Gate Openers |
| |
PRO-SW3000XL—The system chosen by more professionals for high-end estate gates. Designed for extended life cycle residential and light commercial applications, this system blends nicely with any decorative aluminum or ornamental estate gate.
• Will operate
a gate up to 16 ft. (4.9 m) long and weighing up to 650
lbs. (385.6 kg) each leaf.
• Extended Cycle Life - Enhanced motor design makes this operator
ideal for today’s single family estates.
• Works on all types of gates;* chain link, tube, panel, ornamental,
wood and vinyl.
*NOTE: Solid gates create wind resistance and can
affect the performance of the entire gate system. Call technical
service for the best advice for your application.
• Features GTO/PRO’s true soft start and stop
operation. Open and Close times from 18 seconds.
• Full systems capable, control board includes an adjustable
obstruction sensing, gate sequencing and auto close settings.
• U.L. rated for Class I, II, III & IV. System certified
to be in compliance with U.L. 325, 5th edition.
- 24 month limited warranty
•PRO-SW3000XL
Manual
•PRO-SW3200XL
Manual |
 |
| DRIVE
|
| |
• Low friction screw drive (linear actuator) rated for -5 ºF to +160 ºF (-28 ºC to +71 ºC). Use of heater bans on arm and
control box will enhance performance in extreme cold temperatures.
• Powered by a 12 V motor with integral case hardened steel gear reducer. Motor speed reduced to 260 rpm. Generates
820 ft.. lb. of torque at 12 V.
• Maximum opening arc of 110º. Approximate opening time (90º): 20 seconds, depending on weight of gate.
|
 |
| POWER |
| |
• The system is powered by a 12 Vdc, 7.0 Ah, sealed, rechargeable acid battery.
• Battery charge is maintained by a 120 Vac, 18 Vac output transformer rectified to 14.5 Vdc (40 VA) through the GTO
control board. Blade-style control board fuse is rated for 25 A.
NOTE:The transformer should not be directly connected to any battery. Do not replace fuses
with higher ampere rated fuses; doing so will void your warranty and may damage your control board.
• Battery charge is maintained by GTO Solar Panel Charger: float voltage of 14.5 Vdc output from a 193/8" x 81/2"
silicon alloy panel. Generates minimum of 5 W at 300 mA. A gated diode on the control board prevents battery
discharge.
|
| CONTROL |
| |
• GTO microprocessor-based control board is set for single leaf, pull-to-open gate installations. DIP switches can be
adjusted to accommodate an optional kit for push-to-open gates.
• Control board has temperature compensated circuits.
• A circuit on the control board regulates charging. "Sleep draw" is 40 mA; "active draw" is 3 to 7 A.
• Auto-memorization of digital transmitter code.
• GTO remote-mounted RF receiver tuned to 318 MHz.
• Operator length with push-pull tube fully retracted is 401/4", mounting point to mounting point.
• Adjustable auto-close timer (OFF to 120 s), and obstruction sensitivity.
• Power terminal bock accommodates a transformer and solar panels.
• DIP switches simplify setup of gate operator.
• Accessory terminal block fully compatible with push button controls, digital keypads, safety loops, etc.
• Control board allows connection of safety edge sensors and photoelectric sensors.
• Audio entrapment alarm sounds if unit encounters an obstruction twice while opening or closing.
|
| OPERATIONAL
CAPACITY |
| |
The Gate Capacity Chart shows approximate cycles, per day, you can expect from the GTO/PRO® 3000XL Automatic Gate Operator when powered with a transformer. Actual cycles may vary slightly depending upon the type and
condition of gate and installation.
Gate Capacity
Chart
Estimated number of daily cycles, based on use with a transformer and one(1) 12 Volt battery |
| Gate Length |
16 ft. |
160 |
150 |
140 |
130 |
120 |
110 |
100 |
90 |
| 14 ft. |
170 |
160 |
150 |
140 |
130 |
120 |
110 |
100 |
| 12 ft. |
180 |
170 |
160 |
150 |
140 |
130 |
120 |
110 |
| up to 10 ft. |
190 |
180 |
170 |
160 |
150 |
140 |
130 |
120 |
| |
50 lb. |
100 lb. |
150 lb. |
200 lb. |
300 lb. |
400 lb. |
500 lb. |
650 lb. |
| Gate
Weight |
|
|